Skip to content

Water-tank cleaning

Electrician in Umm Al-Jood, Makkah 0565564857 | Water Pumps, Tank Floats and Courtyard Lights

Home electrician in Umm Al-Jood, Makkah

Roof tank empty and the pump silent? Pump running non-stop and water pouring off the roof? Courtyard lights dead just before a family gathering? These are the calls we get most from Umm Al-Jood, and for them we send an electrician in Umm Al-Jood Makkah to sort out the electrical side of the pump, the tank float and the outdoor lighting, then test everything in front of you. Call or WhatsApp 0565564857; we answer 24 hours a day.

Homes here are mostly villas and traditional houses, each with a ground tank, a roof tank and a pump between them, and many with a large courtyard and boundary wall. A big share of the house’s electrics therefore lives outdoors, in the sun and near water, which is far harder on cable and joints than indoor rooms. At Gulf Al-Arab Company we give that part particular care; for the rest of the house, see the home electrician in Makkah page.

Pump, tank and courtyard

  • Water pump: will not start, will not stop, trips the breaker, overheats or runs dry
  • Electric float switches: fitted and wired for both roof and ground tanks to protect the pump
  • Outdoor lighting: courtyard floodlights, wall and facade lights, dusk sensors and timers, occasion lighting
  • Protection: RCD for the pump room and outdoor sockets, sun- and water-resistant cable and boxes
  • Call and WhatsApp: 0565564857

Why most jobs here start at the water tank

In a two-tank house, the pump is the heart. Water arrives from the mains or a tanker into the ground tank; the pump lifts it to the roof tank; gravity carries it to the bathrooms and kitchen. What decides when the pump runs is the electric float switch, or someone climbing to the roof to press a button if there is none.

When that system fails, the whole house feels it within hours. Yet in Umm Al-Jood the fault is usually not the pump itself but what surrounds it: a roof cable cracked by the sun, a junction box with water inside, a tired capacitor, a float stuck in one position. All of those are an electrician’s job and none needs a new pump.

Water pump faults we fix

The pump will not start

We start at the board: has the breaker dropped? Then we measure whether power reaches the pump terminals. If power arrives and the pump hums without turning, the capacitor is the usual suspect, a small part that helps the motor start and wears out with heat and age. If no power arrives, the fault is in the cable, the float breaking the circuit, or the contactor if the pump runs through a control panel.

The pump will not stop

Water coming out of the roof tank overflow means the float has not opened the circuit. Either it is stuck low because of deposits or a tangled cable, or it is wired the wrong way round and starts the pump when the tank is full. We check it, rewire it and set the cable length or weight so it switches off at the right level.

The breaker trips when the pump starts

If it is the RCD, current is probably leaking to the pump body through a damaged winding or water in the junction box. If it is an ordinary breaker, it may be too small for the pump’s starting current, or the pump may be drawing too much because it is turning with difficulty. We measure winding insulation and running current before deciding.

The pump overheats or runs dry

The worst thing for a pump is running with an empty ground tank; it spins without water and overheats until it burns out. The simple electrical answer is a second float in the ground tank that blocks the pump when the level drops. Many houses only have a roof-tank float, which is half the protection.

Water pump and tank float in Umm Al-Jood, Makkah
Wiring a water pump to an electric float switch and its own breaker in an Umm Al-Jood home
What you noticeLikely causeWhat the electrician does
Hum, no rotationFailed capacitor or low voltage at the pumpMeasure voltage, replace the capacitor with the same rating
Total silence, breaker onBroken roof cable or float opening the circuitTrace the cable, test the float, repair the joint
Roof tank overflowingFloat stuck or wired in reverseClean, rewire and set the switching level
RCD trips on start-upWater in the junction box or a damaged windingDry and seal the box, test winding insulation
Pump running very hotDry running or excess currentFit a ground-tank float, check running current
Booster cycles every minutePressure switch out of adjustment or a leakAdjust the switch and check the panel wiring

Float switches for roof and ground tanks

An electric float is a simple switch inside a body that floats, opening or closing the circuit as the level changes. Done properly, there are two wired in series: the roof float says “start” when the level drops, the ground float says “no” when there is nothing to draw. The pump only runs when both agree.

The cable to the roof float usually runs across the roof, and Makkah sun destroys ordinary cable sheathing fast. We run it inside UV-resistant conduit fixed to the wall rather than lying on the floor, use sealed junction boxes against water and dust, and leave enough slack at the tank for the float to move without wrapping around itself. Villas with a second booster pump need it on its own line and breaker, because it starts many times a day and every start pulls a brief surge.

Water and power in the pump room: do not go near the pump with a wet floor or bare feet, and never open its junction box with the breaker on. If water is leaking on or around the pump, switch its breaker off at the board first. The pump room and outdoor sockets must be RCD-protected; they are where water and electricity meet most in a house.

Tank empty and pump down?

Photograph the pump, its nameplate, the float and the board on WhatsApp, and we bring the right part on the first visit.

Call 0565564857WhatsApp 0565564857

Courtyard and facade lighting

The courtyard is where families sit in the evening, where gatherings sometimes happen, and where the car comes in. Good lighting there is about safety as much as looks. But outdoor lighting differs from indoor in every way: fittings sit in sun and dust, joints get splashed during washing or rain, and cables may run under the courtyard floor.

  • LED floodlights rated for outdoor use, aimed at the ground rather than into the neighbours’ windows.
  • Wall lights on the boundary wall and facade, giving the entrance an even, warm light.
  • Short bollards along garden paths, with cable buried inside conduit, never straight in the soil.
  • A dusk sensor that switches on at sunset and off at dawn, or a timer that turns part of it off late at night to save power.
  • Weatherproof outdoor sockets for a vacuum or washer pump, on an RCD-protected circuit.

Before weddings and Eid many people want temporary lighting for the courtyard and wall. We feed it from a separate line with its own breaker, keep cable clear of guest walkways and wet areas, and make sure temporary sockets stay dry. Afterwards we take it down and put everything back if you wish.

Facade and courtyard lighting in Umm Al-Jood, Makkah
Weatherproof floodlights and wall lights over a courtyard and boundary wall in Umm Al-Jood

Traditional houses: roof cabling and annexes

On traditional houses the roof electrics were often added in stages: a cable for the pump, another for a roof room, a third for a floodlight, all lying on the tiles or strung between walls. We gather them into tidy runs inside fixed conduit, give each heavy load its own breaker, and remove taped joints nobody can trace. The result is a cleaner roof, fewer faults, and a clear idea of which breaker controls what.

Other electrical services in Umm Al-Jood

Pumps and outdoor lighting are what we are called for most, but the same electrician handles everything inside the house. Full details on the Makkah home electrician page.

Shorts and outages

Short-circuit detection, partial outages and repeated tripping.

Board and earthing

Board tidied, RCD added, earthing tested and installed.

ACs and heaters

A line and breaker per AC, heaters connected safely.

Sockets and indoor lights

Sockets and switches replaced, chandeliers, spots and fans fitted.

Wiring and annexes

New rooms and annexes wired, old cabling renewed.

Kitchen

Oven, hob and extractor lines, under-cabinet lighting.

Cameras and doorbell

Courtyard and gate cameras, intercom and outer-door bell.

Backup generator

A safe changeover switch that isolates the house from the grid while it runs.

How a visit works in Umm Al-Jood

  1. Call or WhatsApp photos of the pump and its nameplate, the float or tank, and the board.
  2. From the photos we can usually tell whether it is a capacitor, float or cable, so the electrician brings the likely part.
  3. We book the visit, the same day where possible since the house may be without water, and tell you the arrival time.
  4. He checks the pump, both floats, the roof cable and the breaker, and finds the cause.
  5. He explains the fault and agrees the price with you before replacing anything.
  6. He runs the pump until the roof tank fills and it stops by itself, so you can see the float working.
  7. You pay once water is flowing and the pump stops on time; there is a workmanship guarantee on the work, and the technician will tell you its period.

What pump, float and outdoor lighting work costs

A pump needing a capacitor is nothing like one needing a new line from the board to the roof, and one floodlight is not a whole lit wall with a sensor and timer. So we do not publish fixed prices; the electrician sets the price after seeing the job or your photos and videos on WhatsApp, and agrees it with you before starting.

JobWhat sets the price
Pump fault inspectionWhere the pump is, access, and whether the fault is pump, cable or float
Pump capacitor replacementCapacitor rating and type, who supplies it
Electric float installationNumber of floats, cable length to the roof or ground tank, conduit needed
Dedicated pump lineDistance from the board, cable route, breaker type
Courtyard and wall lightingNumber of fittings, run length, trenching or conduit
Dusk sensor or timerDevice type and how many circuits it controls
Temporary occasion lightingCourtyard size, setup time, lighting type

Send photos or a short video on WhatsApp to 0565564857; we reply with a price before we come, confirmed on inspection before any work.

A two-minute monthly check: listen to the pump while it runs; a new hum or a louder note is an early warning. Lift the roof tank lid and check the float moves freely. When you travel for a few days, switch the pump breaker off so it cannot run on its own if the float sticks.

Electrician in Umm Al-Jood and nearby districts

We cover all of Umm Al-Jood, villas and traditional houses alike, and the districts around it. Neighbours have their own pages: electrician in Al-Hamra for rewiring and earthing, electrician in Al-Khadra for ceiling fans and extra sockets, electrician in Al-Rusaifah for apartment-block boards, and electrician in Al-Nawariyah for rest houses and well pumps. Elsewhere in Makkah? Call anyway.

Umm Al-Jood electrician number

Calls and WhatsApp on 0565564857. If the pump is the problem, start your message with “pump” and add photos, so we know the house may be without water and move your request up. Messages are read 24 hours a day.

Water back on, courtyard lit

Pump, float and outdoor lighting checked, a price agreed before work, and payment after testing.

Call 0565564857WhatsApp 0565564857

Searches that lead here

electrician in Umm Al-Jood MakkahUmm Al-Jood electricianhome electrician Umm Al-Joodelectrician Mecca Umm Al Joodwater pump repair Makkahtank float switch installationcourtyard lighting Makkahelectrician near me Makkahelectrician in MakkahGulf Al-Arab Company

Frequently asked questions

What is the Umm Al-Jood electrician number?

0565564857 for calls and WhatsApp. Send a photo of the pump or fault and your location and we book the visit.

Is there an electrician near me in Umm Al-Jood?

Yes. We send an electrician to Umm Al-Jood and nearby areas, the same day where possible, especially when a house has no water.

My pump hums but does not turn. Why?

Usually a failed capacitor or low voltage at the pump. We measure the voltage and replace the capacitor with the same rating if that is the cause.

The roof tank overflows and the pump will not stop. Why?

The float is stuck or wired in reverse. We clean it, rewire it and set the switch-off level.

Do I need a float in the ground tank too?

Yes. It stops the pump running dry and burning out, wired in series with the roof-tank float.

Why does the RCD trip when the pump starts?

Most often water in the junction box or leakage from a winding. We dry and seal the box and test winding insulation.

Do you install courtyard and wall lighting with a sensor?

Yes. Weatherproof floodlights and wall lights with a dusk sensor or timer, on an RCD-protected circuit.

How much does a water pump repair cost?

It depends on the cause and the part needed. Send photos on WhatsApp for a price before the visit, agreed before any work.

ع